Using The Front Lcd; Adding A Default Gateway Using The Lcd - Fortinet FortiGate FortiGate-3016B Install Manual

Configuring

Using the front LCD

1
2
3
4
5
6
7
8
1
2
3
4
5
FortiGate-3016B, FortiGate-3600A and FortiGate-3810A FortiOS 3.0 MR5 Install Guide
01-30005-0343-20071113
config system dns
set primary 293.44.75.21
set secondary 293.44.75.22
set fwdintf internal
end
To configure DNS server settings
Set the primary and secondary DNS server IP addresses. Enter:
config system dns
set primary <address_ip>
set secondary <address_ip>
end
Use the information you recorded in
procedure. Starting with the main menu setting displayed on the LCD, use the
front control buttons and LCD to complete the following procedure.
To change the management IP address and netmask
Press Enter to display the option list.
Use the up or down arrows to highlight Management Interface.
Set the management interface IP address.
Use the up and down arrow keys to increase or decrease the value of each IP
address digit. Press Enter to move to the next digit. Press Esc to move to the
previous digit.
After you set the last digit of the IP address, press Enter.
Use the down arrow to highlight Netmask.
Press Enter and set the management IP Netmask.
After you set the last digit of the Netmask, press Enter.
Press Esc to return to the main menu setting.
Note: When you enter the IP address, the LCD always shows three digits for each part of
the address. For example, the IP address 192.168.100.1 appears on the LCD as
192.168.100.001. The IP address 192.168.23.45 appears as 192.168.023.045.

Adding a default gateway using the LCD

The default gateway is usually configured for the interface connected to the
Internet.
To add a default gateway to an interface
Press Enter to display the interface list.
Use the down arrow key to highlight the name of the interface connected to the
Internet and press Enter.
Use the down arrow to highlight Default Gateway.
Press Enter and set the default gateway.
After you set the last digit of the default gateway, press Enter.
Table 9 on page 41 to complete this
Transparent mode installation
43