Verifying The Web-Based Manager Configuration; Verify The Connection; Using The Command Line Interface; Configuring The Fortigate Unit For Nat/Route Mode - Fortinet FortiGate FortiGate-3016B Install Manual

NAT/Route mode installation

Using the command line interface

36
5 Set Device to the interface connected to the external network.
6 Enter the default gateway IP address.
7 Select OK.

Verifying the web-based manager configuration

To verify access settings, go to the interface you want to verify and select the edit
icon. The Administrative Access field should have check marks beside the settings
you chose in the preceeding steps.

Verify the connection

To verify your connection, try the following:
• browse to www.fortinet.com
• retrieve or send email from your email account
If you cannot browse to the web site or retrieve/send email from your account,
review the previous steps to ensure all information was entered correctly and try
again.
You can also configure the FortiGate unit using the command line interface (CLI).
For information about connecting to the CLI, see
page 20.

Configuring the FortiGate unit for NAT/Route mode

Use the information you gathered in
procedures.
To add/change the administrator password
1 Log into the CLI.
2 Change the admin administrator password. Enter:
config system admin
edit admin
set password <psswrd>
end
To configure interface
1 Log into the CLI.
2 Set the IP address and netmask of the internal interface to the internal IP address
and netmask you recorded in
config system interface
edit <interface>
set mode static
set ip <address_ip> <netmask>
end
FortiGate-3016B, FortiGate-3600A and FortiGate-3810A FortiOS 3.0 MR5 Install Guide
"Connecting to the CLI" on
Table 7 on page 33
Table 7 on page 33. Enter:
Configuring
to complete the following
01-30005-0343-20071113