Fortinet FortiGate FortiGate-3016B Install Manual page 37

Configuring
3
4
5
FortiGate-3016B, FortiGate-3600A and FortiGate-3810A FortiOS 3.0 MR5 Install Guide
01-30005-0343-20071113
Example
config system interface
edit port2
set mode static
set ip 192.168.120.99 255.255.255.0
end
Set the IP address and netmask of the external interface to the external IP
address and netmask you recorded in
config system interface
edit <interface>
set mode static
set ip <address_ip> <netmask>
end
Example
config system interface
edit port1
set mode static
set ip 204.28.1.5 255.255.255.0
end
To set the external interface to use DHCP, enter:
config system interface
edit <interface>
set mode dhcp
end
To set the external interface to use PPPoE, enter:
config system interface
edit <interface>
set mode pppoe
set connection enable
set username <name_str>
set password <psswrd>
end
Use the same syntax to set the IP address of each FortiGate interface as
required.
Confirm that the addresses are correct. Enter:
get system interface
The CLI lists the IP address, netmask, and other settings for each of the FortiGate
interfaces.
Table 7 on page 33.
NAT/Route mode installation
37