Dhcp Or Pppope Configuration; Using The Web-Based Manager; Configuring Basic Settings - Fortinet FortiGate FortiGate-3016B Install Manual

NAT/Route mode installation

DHCP or PPPoPE configuration

Using the web-based manager

34
IP:
Port 16
Netmask:
IP:
Port 17
Netmask:
IP:
Port 18
Netmask:
Default Gateway:
(Interface connected to
external network)
A default route consists of a default gateway and the name of the
Network settings interface connected to the external network (usually the Internet).
The default gateway directs all non-local traffic to this interface and
to the external network.
Primary DNS Server:
Secondary DNS Server:
You can configure any FortiGate interface to acquire its IP address from a DHCP
or PPPoE server. Your Internet Service Provider (ISP) may provide addresses
using one of these protocols.
To use the FortiGate DHCP server, you need to configure an IP address range
and default route for the server. No configuration information is required for
interfaces that are configured to use DHCP.
PPPoE requires you to supply a user name and password. In addition, PPPoE
unnumbered configurations require you to supply an IP address. Use
page 34 to record the information you require for your PPPoE configuration.
Table 8: PPPoE settings
User name:
Password:
You can use the web-based manager for the initial configuration of the FortiGate
unit and all FortiGate unit settings.
For information about connecting to the web-based manager, see
the web-based manager" on page

Configuring basic settings

After connecting to the web-based manager, use the following procedures to
complete the basic configuration of the FortiGate unit.
FortiGate-3016B, FortiGate-3600A and FortiGate-3810A FortiOS 3.0 MR5 Install Guide
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
19.
01-30005-0343-20071113
Configuring
Table 8 on
"Connecting to