Table of Contents
Advertisement
www.seagate.com
1.3.4
Drive mounting
Users can mount the drive in any orientation using four screws in the side-mounting holes or four screws in the
bottom-mounting holes. See
when mounting the drive:
Allow a minimum clearance of 0.030 in (0.76mm) around the entire perimeter of the drive for cooling.
Use only 6-32 UNC mounting screws.
The screws should be inserted no more than 0.140 in (3.56mm) into the bottom or side mounting holes.
Do not overtighten the mounting screws (maximum torque: 6 in-lb).
1.3.4.1
Mechanical specifications
Refer to
Figure 3
Weight:
1.521 lb
NOTE
4X 6-32 UNC 2B
3 MIN THREAD DEPTH
.14 MAX FASTENER PENETRATION
MOUNTING HOLE.
MAX TORQUE 6 IN/LBS
2X 3.000±.010
2X 1.625±.020
.125±.010
1.028
26.11MM
.138 ±.015
Figure 3.
Mounting configuration dimensions
NOTE
Seagate BarraCuda Pro Serial ATA Product Manual, Rev. A
Figure 3
for drive mounting dimensions. Follow these important mounting precautions
for detailed mounting configuration dimensions. See
690 g
These dimensions conform to the Small Form Factor Standard documented in SFF-8301
and SFF-8323, found at
1.432
C L OF DRIVE
3.750±.010
4.000±.010
101.60 ±.25 mm
MAX
2.000
C L OF DRIVE
The image is for mechanical dimension reference only and may not represent the actual drive.
www.snia.org/technology-communities/sff/specifications.
4.000±.010
B
1.122±.020
28.50 ±.51 mm
.814
Y
C L OF CONN
2.000
Z
Configuring and mounting the drive
Section
1.3.4, "Drive mounting."
Z
5.787
146.
1.638±.010
Y
.250±.010
2X 6-32 UNC 2B
3 MIN THREAD DEPTH
.14 MAX FASTENER PENETRATION
MOUNTING HOLES BOTH SIDES.
MAX TORQUE 6 IN/LBS
MAX
MM
26
Advertisement
Table of Contents
