Reconnecting To The Web-Based Manager; Using The Front Control Buttons And Lcd - Fortinet FortiGate FortiGate-3000 Installation Manual
Fortinet fortigate fortigate-3000: install guide
Hide thumbs
Also See for FortiGate FortiGate-3000:
- Administration manual (398 pages) ,
- Install manual (66 pages) ,
- Installation manual (3 pages)
Table of Contents
Advertisement
Transparent mode installation
Reconnecting to the web-based manager
Using the front control buttons and LCD
FortiGate-3000 Installation Guide
To configure DNS server settings
1
Go to System > Network > DNS.
2
Enter the IP address of the primary DNS server.
3
Enter the IP address of the secondary DNS server.
4
Select OK.
To configure the default gateway
1
Go to System > Network > Management.
2
Set Default Gateway to the default gateway IP address that you recorded in
on page
40.
3
Select Apply.
If you changed the IP address of the management interface while you were using the
setup wizard, you must reconnect to the web-based manager using the new IP
address. Browse to https:// followed by the new IP address of the management
interface. Otherwise, you can reconnect to the web-based manager by browsing to
https://10.10.10.1. If you connect to the management interface through a router, make
sure that you have added a default gateway for that router to the management IP
default gateway field.
This procedure describes how to use the control buttons and LCD to configure
Transparent mode IP addresses. Use the information that you recorded in
page 40
to complete this procedure. Starting with Main Menu displayed on the LCD,
use the front control buttons and LCD:
1
Press and hold the Esc button until Main Menu appears (after four seconds).
2
Press Enter three times to configure the management interface IP address.
3
Set the manager interface IP address.
Use the up and down arrow keys to increase or decrease the value of each IP address
digit. Press Enter to move to the next digit. Press Esc to move to the previous digit.
Note: When you enter an IP address, the LCD always shows three digits for each part of the
address. For example, the IP address 192.168.100.1 appears on the LCD as 192.168.100.001.
The IP address 192.168.23.45 appears as 192.168.023.045.
4
After you set the last digit of the IP address, press Enter.
5
Use the down arrow to highlight Netmask.
6
Press Enter and set the management IP Netmask.
7
After you set the last digit of the Netmask, press Enter.
8
Press Esc to return to the Main Menu.
9
Repeat these steps to configure the default gateway, if required.
01-28005-0026-20041101
Using the front control buttons and LCD
Table 9
Table 9 on
41
Advertisement
Table of Contents
