Starting The Setup Wizard; Reconnecting To The Web-Based Manager; Connecting The Fortigate Unit To The Network(S) - Fortinet FortiGate FortiGate-400 Installation Manual

NAT/Route mode installation

Starting the setup wizard

Reconnecting to the web-based manager

Connecting the FortiGate unit to the network(s)

FortiGate-400 Installation Guide
Table 7: Setup wizard settings
Antivirus
1 In the web-based manager, select Easy Setup Wizard.
Figure 8: Select the Easy Setup Wizard
2 Follow the instructions on the wizard pages and use the information that you gathered
in Table 5 on page 26
3 Select the Next button to step through the wizard pages.
4 Confirm the configuration settings, and then select Finish and Close.
If you changed the IP address of port 1 while you were using the setup wizard, you
must reconnect to the web-based manager using the new IP address. Browse to
https:// followed by the new IP address of port 1. The default address of port 1 is
https://192.168.1.99.
You are now finished the initial configuration of the FortiGate unit, and can proceed to
"Next steps" on page
After you complete the initial configuration, you can connect the FortiGate unit
between the internal network and the Internet.
High Create a protection profile that enables virus
scanning, file blocking, and blocking of oversize
email for HTTP, FTP, IMAP, POP3, and SMTP. Add
this protection profile to a default firewall policy.
Medium Create a protection profile that enables virus
scanning, for HTTP, FTP, IMAP, POP3, and SMTP
(recommended). Add this protection profile to a
default firewall policy.
None Do not configure antivirus protection.
Select one of these security levels to protect your network from viruses.
and Table 7 on page 32
35.
01-28004-0022-20040830
Connecting the FortiGate unit to the network(s)
to fill in the wizard fields.
33