Getting Started - Remington i-LIGHT IPL6750 Manual

Hide thumbs Also See for i-LIGHT IPL6750:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
ENGLISH
DO NOT use on skin with cosmetics applied, as treating in those areas could temporarily cause skin swelling, blisters
or could change the colour of your skin. Make sure to thoroughly clean the intended treatment area prior to use.
DO NOT flash the same treatment spot multiple times during the same session, as this could temporarily cause skin
swelling, blisters, or could change the colour of your skin.
DO NOT treat any area more than every two weeks, as this will not speed up results, but could increase likelihood of
skin swelling, blistering or changing the colour of your skin.
DO NOT use on damaged skin, including open wounds, cold sores, sunburns, or areas where you have had a skin
peel or other skin resurfacing procedure within the last 6-8 weeks.
DO NOT use on irritated skin, including rashes or swollen skin. These conditions can make the skin more sensitive.
Wait for the affected area to heal before use.
DO NOT use if your skin is sensitive to light. In order to determine if you can use i-LIGHT, perform a test on a small
patch of skin and wait 24 hours to determine if there are any adverse reactions before treating more broadly.
DO NOT use if you are or may be pregnant or are breast-feeding. i-LIGHT has not been tested on pregnant women.
Hormonal changes are common during pregnancy or breast-feeding and could increase skin sensitivity and the risk
of skin injury.
DO NOT flash against any material other than skin.
DO NOT use i-LIGHT for any purpose other than hair removal.
DO NOT treat any area where you may someday want your hair to grow back. The results may be permanent and
irreversible.
DO NOT use on the face if you have a history of cold sores; use of IPL or any treatment that irritates skin can cause a
recurrence of cold sores.
If you've had professional or clinical or self-administered laser or IPL or electrolysis hair removal treatments, wait at
least 6 months before using i-LIGHT. If you've waxed, plucked or epilated hair in the treatment area, wait at least 6
weeks before using i-LIGHT. The device uses the hair under your skin to disable your hair at the root, so it is not effec-
tive if the hair has been pulled out.
Do not use over or near anything artificial such as silicon implants, Implanon contraceptive implants, pacemakers,
subcutaneous injection ports (insulin dispenser) or piercings.
DO NOT use directly over or near Active Implantable Medical Devices such as implantable pacemaker, internal defi-
brillator, or insulin devices. Although no problems associated with the use of this device have been reported during
studies, it is recommended to observe all active implantable medical device warnings regarding the use of electronic
devices to prevent any failure or interruption of an active implantable device.
Wireless communications equipment may affect the i-LIGHT device and should be kept at least 3.3 m away.
Do not use over or near fillings or dental implants.
KEY FEATURES (FIG 3)
1. Power Switch
2. Power Inlet
3. Base Unit
4. Hand Piece
5. Flash Button
6. Energy Level Selection Button
7. Cool Down Mode Indicator
8. Bulb Status Indicator Display
9. Energy Level Indicator
10. Skin Tone Sensor
11. Hand Piece Cord

GETTING STARTED

Fold out the front and rear pages of this instruction manual so you can refer to the diagrams while you are reading.
Be patient when first using your i-LIGHT, as with any new product, it may take a little while to familiarise yourself with
the product. Take the time to acquaint yourself with your i-LIGHT as we are confident you will receive years of enjoyable
use and complete satisfaction.
6
12. Flash Window
13. Skin Contact Sensors
14. Attachment Release Buttons
15. Bulb
16. Body Attachment
17. Power Cord
18. Lint Free Cloth
19. Facial Attachment
20. Bikini Attachment
21. Spare lamp (not shown)

Advertisement

Table of Contents
loading

Table of Contents