Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Remington i-Light Smooth Sense
Summary of Contents for Remington i-Light Smooth Sense
- Page 1 3 YEAR WARRANTY IPL8500AU...
- Page 2 SKIN CHART THE SKIN CHART HAIR COLOUR WARNING: i-LIGHT® is not suitable for very dark or black skin, white/grey or very light blonde/red hair. FOR FACIAL USE: Only suitable for female facial use below the cheekbone. DO NOT use on or around the eyes, eyebrows or eyelashes.
-
Page 3: Important Safety Instructions
THANK YOU FOR BUYING YOUR NEW REMINGTON® PRODUCT. PLEASE READ THESE INSTRUCTIONS CAREFULLY AND KEEP THEM SAFE. REMOVE ALL PACKAGING BEFORE USE. IMPORTANT SAFETY INSTRUCTIONS WARNING – TO REDUCE THE RISK OF BURNS, ELECTROCUTION, FIRE, OR INJURY TO PERSONS: 1. Use this appliance only for its intended use described in this manual. -
Page 4: Warnings And Safety Information
WARNINGS AND SAFETY INFORMATION IMPORTANT SAFETY CAUTIONS Before you start using i-LIGHT®: Be sure to read all Warnings and Safety Information. Before you begin, check to see if i-LIGHT® is suitable for you. Use the skin and hair chart at the front of this manual (page 2) and the integrated skin sensor to determine if this device is right for you. - Page 5 • DO NOT use on skin with cosmetics applied, as treating in those areas could temporarily cause skin swelling, blisters or could change the colour of your skin. Make sure to thoroughly clean the intended treatment area prior to use. •...
-
Page 6: Key Features
WARNINGS AND SAFETY INFORMATION (cont.) • DO NOT use directly over or near Active Implantable Medical Devices such as implantable pacemakers, internal defibrillators, or insulin devices. Although no problems associated with the use of this device have been reported during clinical studies, it is recommended to observe all active implantable medical device warnings regarding the use of electronic devices to prevent any failure or interruption of an active implantable device. - Page 7 SMOOTH SENSE® KEY FEATURES...
-
Page 8: Getting Started
GETTING STARTED Be patient when first using your i-LIGHT® Smooth Sense, as with any new product, it may take a little while to familiarise yourself with the product. Take the time to acquaint yourself with your i-LIGHT® Smooth Sense as we are confident you will receive years of enjoyable use and complete satisfaction. - Page 9 Hair grows in a cycle of 3 different phases with a full cycle lasting 18-24 months (Fig 3). Only hairs in the active growth phase are susceptible to treatment, which is why multiple treatments are required for optimal results (Fig 3). Fig 3 Anagen Phase Catagen Phase...
-
Page 10: Operating Mode
FAMILIARISE YOURSELF WITH YOUR i-LIGHT® SMOOTH SENSE Familiarise yourself with the features of your new i-LIGHT® Smooth Sense device. Flash Window with Built-In UV Skin Protection • WARNING: Always inspect the Flash Window before use to ensure there is no damage to the lens (Fig 4). •... - Page 11 Attachments • Body Attachment Cap for large areas below the neck (Fig 8). • Precision Treatment Attachment Cap for smaller female facial areas such as cheeks, sideburns, chin, neck area and above the lips. It can also be used Fig 8 on other smaller areas such as the underarms and bikini area (Fig 9).
-
Page 12: Preparing For Use
PREPARING FOR USE Check Your Skin Tone • To determine if your skin tone is suitable for use with the device, compare your skin in the intended treatment areas with the Skin Tone Chart (Page 2). • If your skin matches either the light, medium or dark skin tones in the Skin Tone Chart (I-V), you can use this i-LIGHT®... -
Page 13: Flash Button
Power Mode (Default Mode) Power Mode will provide the highest power level that is appropriate for you. This mode is ideal for treating both larger and smaller areas. Power Mode will give you the best hair removal results in fewer treatments, but may be less comfortable. - Page 14 Test The i-LIGHT® Smooth Sense On Your Skin Before your first full treatment, test the i-LIGHT® Smooth Sense on a small patch of skin and wait 24 hours to ensure there are no adverse reactions. 1. Select your preferred mode and wait until the Skin Tone Tester lights blink to amber before placing device on the skin.
-
Page 15: Multi-Flash Mode
To Change Attachments WARNING: Always ensure the unit is OFF and the power cord is disconnected before removing the attachments. Allow the system to cool down for 5 minutes before attempting to change the Treatment Cap 1. Turn the Power Switch OFF and unplug the Power Cord from the electrical outlet. 2. -
Page 16: Treatment Tips
• For multi-flash mode, keep your finger on the Flash Button to keep it depressed and glide to the next area being sure to keep the Skin Contact Sensors fully engaged. The next flash will be delivered automatically after 3 seconds (in Full Power Mode). •... -
Page 17: Post-Treatment Care
• The bulb in this device is guaranteed to last for the entire warranty period as communicated on the warranty details at the rear of this manual. • In the extremely unlikely event that your bulb becomes empty, please contact your local Remington® Service centre. -
Page 18: Troubleshooting
Sense, as this section addresses the most common problems you could encounter with i-LIGHT® Smooth Sense. If you have followed the instructions in this section and continue to experience problems, please contact the Remington® Service Centre for further assistance. The power switch is ON, but the unit is not working. -
Page 19: Frequently Asked Questions
• If you have concerns about using the unit, discontinue use and contact the Remington® Service Centre for further assistance. I have switched the unit ON, but I cannot increase or decrease the energy level. • Try resetting the unit by turning it off and waiting several seconds before turning it back on. -
Page 20: Environmental Protection
• If you call the Service Centre, please have the Model No. on hand, as we won’t be able to help you without it. The Model No. can be found on the rating plate of the appliance. • Replacement accessories are available to buy through your Remington® Service Centre. -
Page 21: Technical Information
TECHNICAL INFORMATION Normal Mode: Sensitive Mode: Express Mode: • Light Skin: 8J/cm • Light Skin: 7J/cm • 2.5J/cm Appliance optical output • Dark Skin: 6J/cm • Dark Skin: 5.1J/cm Wavelength range 650 - 1200nm Normal Mode: Sensitive Mode: Express Mode: Pulse duration 42ms 42ms... -
Page 22: Warranty Against Defects
Spectrum Brands Australia Pty Ltd and Spectrum Brands New Zealand Limited WARRANTY AGAINST DEFECTS In this warranty: Australian Consumer Law means the Australian consumer law set out in Schedule 2 to the Competition and Consumer Act 2010; CGA means the New Zealand Consumer Guarantees Act 1993; Goods means the product or equipment which was accompanied by this warranty and purchased in Australia or New Zealand, as the case may be;... -
Page 23: Warranty Conditions
Warranty Conditions 4. The Goods must be used in accordance with the manufacturer’s instructions. This Warranty does not apply should the defect in or failure of the Goods be attributable to misuse, abuse, accident or non-observance of manufacturer’s instructions on the part of the user. As far as the law permits, the manufacturer does not accept liability for any direct or consequential loss, damage or other expense caused by or arising out of any failure to use the Goods in accordance with the manufacturer’s instructions. - Page 24 New Zealand 0800 736 776 (toll free) AUTHORISED REPAIR CENTRES Visit www.remington-products.com.au for authorised repair centre details. Remington® and i-LIGHT® are registered trademarks of Spectrum Brands, Inc., or one of its subsidiaries. Made in China to the specifications of Spectrum Brands, Inc.