Maintenance And Service; Quick Reference Maintenance Guide - Quadra-Fire 43M-ACC-NZ Owner's Manual

3

Maintenance and Service

A. Quick Reference Maintenance Guide
Start the first inspection after the first 2 months of use,
or if performance changes, and adjust your schedule
accordingly. Maintenance is required for safe operation and
must be performed to maintain your warranty.
Baffl e & Blanket
Baffle Retainer
Ceramic Blanket
Bracket
Baffle Board
Chimney System
Firebrick & Ash Removal
Door & Glass Assemblies
Door Handles
Table 15.1
15
FREQUENCY
MONTHLY
Back of Firebox
or after every
one (1) cord of
wood
EVERY TWO
MONTHS
or after every
four (4) cords of
wood
WEEKLY
or after every 25
loads of wood
WEEKLY
or after every 25
loads of wood
WEEKLY
or after every 25
loads of wood
These are generic drawings and may not represent your model.
Allow the appliance to completely cool down before
performing any cleaning or maintenance.
Baffl e and blanket placement is critical to heat output, effi ciency and
overall life of the appliance. Make sure the baffl e is pushed all of the
way to the back of the fi rebox and the blanket is laying fl at. Inspect
baffl e for cracks.
The chimney and chimney cap must be inspected for soot and
creosote every two months during the burn season or more frequency
if chimney exceeds or is under 14-16 ft (4.3m-4.8m) measured from
bottom of appliance.
This will prevent pipe blockage, poor draft, and chimney fi res.
Always burn dry wood to help prevent cap blockage and creosote
build-up.
Ashes must be cool before you can dispose of the ashes in a non-
combustible container.
Firebrick is designed to protect your fi rebox. After ashes are removed,
inspect the fi rebrick and replace fi rebricks that are crumbling, cracked
or broken.
Keep door and glass gasket in good shape to maintain good burn.
To test: place a dollar bill between the appliance and door and then
shut the door. If you can pull the dollar out, remove one washer from
door handle behind latch cam and try again. If you can still pull it out,
replace the door gasket.
Check the glass frame for loose screws to prevent air leakage.
Check glass for cracks.
Check the door latch for proper adjustment. This is very important
especially after the door rope has formed to the appliance face.
Check door handle for smooth cam operation.
7037-182C
CAUTION!
TASK
04/21