Transparent Mode Installation; Preparing To Configure Transparent Mode; Using The Web-Based Manager - Fortinet FortiGate FortiGate-100 Install Manual

Configuring the FortiGate unit

Transparent mode installation

Preparing to configure Transparent mode

Using the web-based manager

1
2
3
4
5
FortiGate-50A/50B, FortiWiFi-50B and FortiGate-100 FortiOS 3.0 MR4 Install Guide
01-30004-0265-20070831
This section describes how to install the FortiGate unit in NAT/Route mode. This
section includes the following topics:
• Preparing to configure Transparent mode
• Using the web-based manager
• Using the command line interface
• Connecting the FortiGate unit to your network
Use Table 14 to gather the information you need to customize Transparent mode
settings.
You can configure Transparent mode using one of the following methods:
• the web-based manager GUI
• the command line interface (CLI)
The method you choose depends on the complexity of the configuration, access
and equipment, and the type of interface you are most comfortable using.
Table 14: Transparent mode settings
Administrator Password:
IP:
Netmask:
Default Gateway:
Management IP
The management IP address and netmask must be valid for the
network from which you will manage the FortiGate unit. Add a default
gateway if the FortiGate unit must connect to a router to reach the
management computer.
Primary DNS Server:
DNS Settings
Secondary DNS Server:
You can use the web-based manager to complete the initial configuration of the
FortiGate unit. You can continue to use the web-based manager for all FortiGate
unit settings.
For information about connecting to the web-based manager, see
the web-based manager" on page
The first time you connect to the FortiGate unit, it is configured to run in
NAT/Route mode.
To switch to Transparent mode using the web-based manager
Go to System > Status.
Select Change beside the Operation Mode.
Select Transparent in the Operation Mode list.
Type the Management IP/Netmask address and the Default Gateway address you
gathered in Table 14 on page
Select Apply.
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
21.
43.
Transparent mode installation
"Connecting to
43