Document Conventions; Typographic Conventions - Fortinet FortiGate FortiGate-100 Install Manual

Introduction

Document conventions

FortiGate-50A/50B, FortiWiFi-50B and FortiGate-100 FortiOS 3.0 MR4 Install Guide
01-30004-0265-20070831
This document contains the following chapters:
• Installing the FortiGate unit
on a FortiGate unit.
• Factory defaults – Provides the factory default settings for the FortiGate unit
• Configuring the FortiGate unit
of the FortiGate unit and how to integrate the FortiGate unit into your network.
• Configuring the modem interface
modem with the FortiGate-50A and FortiGate-50AM units.
• Using a wireless network
postioning the FortiWiFi-50B unit for best reception.
• FortiGate Firmware – Describes how to install, update, restore and test the
firmware for the FortiGate device.
Note: This guide covers information on four FortiGate units; the FortiGate-50A,
FortiGate-50B, FortiWiFi-50B and FortiGate-100. While most of the content applies to all
the units, where information is specific to a certain model, an icon like the ones below will
appear next to the content.
50B
50A
The following document conventions are used in this guide:
• In the examples, private IP addresses are used for both private and public IP
addresses.
• Notes and Cautions are used to provide important information:
Note: Highlights useful additional information.
Caution: Warns you about commands or procedures that could have unexpected or
undesirable results including loss of data or damage to equipment.

Typographic conventions

FortiGate documentation uses the following typographical conventions:
– Describes unpacking, setting up, and powering
– Provides an overview of the operating modes
– Describes how to configure and use a
– Describes configuring a wireless network and
WiFi-50B
100
About this document
11