Installing Units - Hatco GR Series Installation And Operating Manual

English

Installing Units

Strip heaters can be mounted with tubular stands or angle
brackets. Refer to the proper mounting section for the
installation procedure.
Tubular Stand Mounting
Tubular stand mounting permanently attaches the unit to a
countertop or serving table. All wiring may be concealed within
one of the tubular stands.
CAUTION
To ensure safe and proper operation, refer to the Clearance
Requirements listed in the INSTALLATION section of this
manual.
Non-adjustable tubular stands are available in aluminum,
Designer colors, or gloss finishes in heights from 254–406 mm
(10"–16"). Adjustable tubular stands are available in stainless
steel in heights from 254–356 mm (10"–14").
NOTE: Tubular stands are not field retrofittable.
NOTE: If wiring is to be concealed, a 25 mm (1") diameter hole
must be provided in the mounting surface under the
stand containing the wiring conduit.
1. Position the unit upside-down on a flat surface.
NOTE: Units for this application are supplied with the conduit
attached to one side of the unit. Conduit should not be
removed.
2. If applicable, prepare the mounting surface for concealing
wiring.
a. Cut a 25 mm (1") diameter hole into the mounting
surface at the appropriate location.
NOTE: The distance between the center of the two stands is
found by subtracting 60 mm (2-3/8") from the overall
length of the strip heater.
b. Route the flexible conduit through the tubular stand and
into the mounting surface.
30 mm (1-3/16")
Mounting Hole Distance =
Width (A) minus 60 mm (2-3/8")
Countertop Conduit Hole Dimension
Form No. GRM_CN-0818
A
3. Secure the conduit-side stand to the unit using the screws
supplied.
4. Align the opposite-side stand with the mounting holes at
the other end of the unit and secure the stand to the unit
using the screws supplied.
5. Secure the stands to the mounting surface.
NOTE: The adjustable stands can be raised or lowered by
turning the locking set screw counterclockwise one
turn with an Allen wrench. After loosening the set
screw, raise or lower the unit to the desired height and
retighten the screw. Do not loosen the screw more than
necessary.
NOTE: Two pairs of stands will be needed for mounting dual
units.
Set
Screw
Mounting
Screw
Adjustable
Stand
Tubular Stand Mounting
13
INSTALLATION
Non-Adjustable
Stand
Flexible
Conduit