Dukane 8950W User Manual page 60

OPTION menu
It e m
A UTO
K E Y S TO NE
D IR E C T PO W E R
O N
A UTO PO W E R
O F F
(continued on next page)
6 0
Using the ▲/▼ buttons turns on/off the automatic keystone function.
ON ó OFF
ON : Automatic keystone distortion correction will be executed
whenever changing the slant of the projector.
OFF : This function is disabled. Please execute the AUTO
KEYSTONE (EXECUTE) in the SETUP menu for automatic
keystone distortion correction.
• When the projector is suspended from the ceiling this feature will
not function properly so select the OFF.
• This function will be unavailable when the TRANSITION
DETECTOR ( 78) is ON or the screen is adjusted by PERFECT
FIT ( 47).
Using the ▲/▼ buttons turns on/off the DIRECT POWER ON
function.
ON ó OFF
When set to the ON, the lamp in projector will be automatically turned
on without the usual procedure ( 21), only when the projector is
supplied with the power after the power was cut while the lamp was on.
• This function does not work as long as the power has been
supplied to the projector while the lamp is off.
• After turning the lamp on by the DIRECT POWER ON function,
if neither input nor operation is detected for about 30 minutes, the
projector is turned off, even though the AUTO POWER OFF function
( 60) is disabled.
Using the ▲/▼ buttons adjusts the time to count down to
automatically turn the projector off.
Long (max. 99 minutes) ó Short (min. 0 minute = DISABLE)
When the time is set to 0, the projector is not turned off automatically.
When the time is set to 1 to 99, and when the passed time with
no-signal or an unsuitable signal reaches at the set time, the
projector lamp will be turned off.
If one of the projector's buttons or the remote control buttons
is pressed or one of the commands (except get commands) is
transmitted to the C O NTR O L port during the corresponding time,
the projector will not be turned off.
Please refer to the section Tu r n i n g o f f t h e p o w e r ( 22).
D e s c r i p t i o n