Connecting To A Power Supply; Fastening The Cable - Dukane 8950W User Manual

Setting up

Connecting to a power supply

1.
Put the connector of the power cord into the
A C (AC inlet) of the projector.
2.
Firmly plug the power cord's plug into the
outlet. In a couple of seconds after the
power supply connection, the PO W E R
indicator will light up in steady orange.
Please remember that when the DIRECT POWER
ON function activated (60), the connection of the
power supply make the projector turn on.
WARNING
incorrect or faulty connections may result in fire and/or electrical shock.
• Do not touch the power cord with a wet hand.
• Only use the power cord that came with the projector. If it is damaged, consult
your dealer to get a new one. Never modify the power cord.
• Only plug the power cord into an outlet whose voltage is matched to the power
cord. The power outlet should be close to the projector and easily accessible.
Remove the power cord for complete separation.
• Do not distribute the power supply to multiple devices. Doing so may overload
the outlet and connectors, loosen the connection, or result in fire, electric shock
or other accidents.
• Connect the ground terminal for the AC inlet of this unit to the ground terminal
of the building using an appropriate power cord (bundled).
NOTICE
►This product is also designed for IT power systems with a phase-to-
phase voltage of 220 to 240 V.

Fastening the cable

Use the supplied cable tie to fasten the cable.
1 6
►Please use extra caution when connecting the power cord, as
C a b l e t i e
A C
Po w e r
c o r d