Daikin GQI-Eco Series Service Manual page 82

Field Setting from Remote Controller
The largest time interval
for Dust Collection Sign
2 Display for "self
cleaning decoration
panel"
Display or non-display
of green lamp on the
14
4
selfcleaning decoration
(24)
panel
Auto control operation
8
for Filter Auto Cleaning
Filter cleaning time for
9 "selfcleaningdecoration
panel"
15 Individual setting of
5
(25) ventilation
1b Wind block (note 7)
14
(2b) enable / disable setting
1. Settings are made simultaneously for the entire group, however, if you select the mode No.
Note:
*2. For FHQG, the second code No. of the "Airflow range setting is set at "03".
3. "88" may be displayed to indicate the remote controller is resetting when returning to the
4. This function does not work when "SET BACK Function" is set by remote controller.
5. This is the case when the remote sensor (optional kit) is used.
6. This is the case when the sensor option (optional kit) is used.
7. Wind block: one of 4 flaps can be set a block position. (block position = closed position)
2.3.1 Detailed Explanation of Setting Modes
Filter Cleaning Sign Interval
When "Display" is selected in "Filter cleaning sign" after the unit runs for certain time, "Filter
cleaning" will be displayed on the remote controller. This setting is used when the display
interval of "Filter cleaning" needs to be changed on occasions such as when the filter has been
heavily contaminated.
Mode No.
Remote Controller Thermistor
Select the thermistor to control room temperature.
The factory setting for the Second Code No. is "02" and room temperature is controlled by the
indoor unit suction air thermistor.
When the Second Code No. is set to "01", room temperature is controlled by the indoor unit
suction air thermistor and the room temperature thermistor in remote controller as following
figures.
68
About 1250 hrs
(Dusty place)
Display both: -
airconditioning
operation, -filter
auto cleaning
Auto control
operation
Normal place in
terms of dust
(Normal office)
Normal
Enable
inside parentheses, you can also set by each individual unit. Setting changes however
cannot be checked except in the individual mode for those in parentheses. (Even if the
setting are made for the entire group, the display always indicates "01".)
normal mode.
Wind can not be blocked 100% but mostly blocked without additional parts.
First Code Second
No. Code No.
10 (20) 0
First Code
Mode No.
No.
10 (20) 2
About 2500 hrs
Non display: -
airconditioning
operation,
Display: -filter auto
cleaning
Not auto control
operation
In case of dusty
place
Individual
operation
—
Long Life Filter
01 2,500 hrs.
02 1,250 hrs.
Second
Thermistor that controls room temperature
Code No.
Room temperature thermistor in remote controller and
01
indoor unit suction air thermistor
02 Indoor unit suction thermistor
About 5000 hrs
(less dusty —
place)
Display: -
airconditioning
operation, Non —
display: -filter
auto cleaning
— —
— —
— —
— —
Setting
Contamination Light
Contamination Heavy
ESIE15-13B
—
—
—
—
—
disable
Field Setting