Table of Contents
Advertisement
Installation and Connection
Installation and Connection
Parts list for installation
Note: This parts list does not include all the package
contents.
¥ Wiring harness (× 1)
ø Extension wire, 2 m (× 1)
π Microphone, 3 m (× 1)
[ Flat head screws (M5 x 8 mm) (× 6)
" Round head screws (M5 x 8 mm) (× 6)
] Steering Remote cable (× 1)
Only for DDX4018BT:
' Trim plate (× 1)
Installation procedure
1
Remove the key from the ignition and
disconnect the
battery.
·
2
Make the proper input and output wire
connections for each unit.
3
Connect the speaker wires of the wiring
harness.
4
Connect the wires of the wiring harness
in the following order: ground, battery,
ignition.
5
Connect the wiring harness connector to
the unit.
6
Install the unit in your car.
Make sure that the unit is installed securely in place.
If the unit is unstable, it may malfunction (e.g., the
sound may skip).
7
Reconnect the
battery.
·
8
Press the reset button on the monitor
panel. (Page 4)
9
Configure <Initial Settings>. (Page 5)
Installing the unit
Car bracket
Select the appropriate type of screw for the mounting
bracket: flat head ([) or round head (").
Installing the trim plate
(Only for DDX4018BT)
Connecting external components
1 Navigation input (NAV)
2 Steering wheel remote controller input (REMO-IN)
• Connect to the car's steering remote harness.
Contact your KENWOOD dealer for details.
3 Microphone input (MIC) (Page 46)
4 Audio video input (AV-IN)
Connect the following type of 4-pole mini plug:
1 Left audio
2 Right audio
3 Ground
4 Composite video
5 Video output (V-OUT)
6 Rear view camera input (R-CAM)
7 Output terminals*
• Left output (White)
• Right output (Red)
REAR: Rear speaker preouts
FRONT: Front speaker preouts
SW: Subwoofer preouts
* When connecting an external amplifier, connect its ground wire
to the chassis of the car; otherwise the unit may be damaged.
ENGLISH
45
Hide quick links:
Advertisement
Table of Contents
