Table of Contents
Advertisement
Installation and Connection
Installation and Connection
Installation procedure
1
Remove the key from the ignition and
·
disconnect the
battery.
2
Make the proper input and output wire
connections for each unit.
3
Connect the speaker wires of the wiring
harness.
4
Connect the wires of the wiring harness
in the following order: ground, battery,
ignition.
5
Connect the wiring harness to the unit.
6
Install the unit in your car.
Make sure that the unit is installed securely in place.
If the unit is unstable, it may malfunction (eg., the
sound may skip).
7
·
Reconnect the
battery.
8
Initialise the unit (page 45).
9
Configure <Initial Setup> (page 4).
50
ENGLISH
Installing the unit
Installing the unit using the mounting
bracket removed from the car
π / [
Note: Select the appropriate screws (supplied) for the
mounting bracket.
* Shape of your car brackets may differ.
For Toyota cars
Install onto the car bracket using the supplied screws
([). Use the mounting holes (A or B) that fit the car
bracket.
Side view
Installing the unit using the mounting
sleeve
π / [
\
Car bracket*
Bend the tabs of the mounting sleeve with a
screwdriver or similar utensil and attach it in place.
Installing the trim plate
For Toyota cars
'
]
Advertisement
Table of Contents
