Table of Contents
Advertisement
MENU08：Steering sub trim
▶This function allows you to adjust the edge of operation
and neutral position at the same time.
(Use when installing servo and test running)
Adjust using
＋/− keys. Push both keys together to reset.
Adjust "MENU02: Steering trim" to adjust neutral position only.
When value of the sub trim gets bigger, adjust the linkage and
make it a smaller the value. In certain circumstances, too big
value may cause dead area (servo does not react) at the edge
of operation.
MENU09：Steering reverse
▶This function allows you to change the direction
of servo movement
(Use this function when the turning direction of servo
is opposite to the transmitter operation)
Adjust using
＋/− keys. Push both keys together to reset.
※REV：Reverse NORM：Normal
MENU10：Throttle monitor
▶Displays current throttle position.
If throttle direction is in reverse position, throttle movement
and F/b indication of monitor will be reversed accordingly.
MENU11：Throttle trim
▶Adjust neutral position of throttle while running
Adjust using
＋/− keys. Push both keys together to reset.
In general, trim adjustment is not required when using with
electric car with preset electronic speed controller (ESC).
The position of the end point does not move. Only the neutral
position moves.
When changing the edge of movement, adjust in "MENU17:
Throttle sub trim".
Throttle trim can also be adjusted by using ET2 lever.
L25 〜 0 （Default setting） 〜 R25
REV （Default setting） ／ NORM
Neutral position
b50 〜 0 （Default setting） 〜 F50
■MENU 08〜11
+ key
− key
+ key
− key
ET2 lever
+ key
− key
9
Advertisement
Table of Contents
