Table of Contents
Advertisement
Safety function
▶Failsafe setting
Failsafe automatically returns throttle (2ch) in desired position (full brake/neutral) if the model may run out
of control.
① Switch transmitter on.
② Switch receiver on and check servo movement.
③ Hold the throttle trigger in the desired brake/neutral
position. (transmitter memorizes the position)
④ Hold set button of receiver more than 3 seconds.
Release after LED turns off.
※Failsafe function can be checked by switching
off transmitter. The data will be memorized until
resetting.
※When replacing brake linkage of a gas car,
resetting is recommended.
References
●Model does not work though the transmitter is on
LCD display is displayed with the start sound after switching on. If not, check batteries.
If there is no problem with transmitter, check LED indicator of the receiver.
① In case of the LED is too dark or blinking, it shows conflicting radio signals from other
sources. Change location or take some time before switching on.
②Power is not on if the LED does not shine. Reconnect receiver battery or amplifier cables.
●To increase cornering angle
If steering angle is not enough, adjust steering travel lever to increase travel.
Use MENU04/05: steering balance to get more angle.
●To improve steering response
Adjust MENU07: steering curve or MENU06: steering speed at ＋(quick) side.
●To make steering characteristics milder
Adjust MENU07: Steering curve or MENU06: Steering speed at −(mild) side.
Adjust MENU07: Throttle speed at -side.
●To slow down
Adjust MENU14: Throttle speed at −side.
Adjust MENU12: Throttle high point at −side.
2. Power
4. Set button (hold 3 seconds)
■ Safety function／References
1. Power
3. Throttle trigger
(full brake/neutral)
5. LED (off)
15
Advertisement
Table of Contents
