Table of Contents
Advertisement
▶How to pairing
Register receiver to the transmitter
① Hold both Forward and Back keys and switch transmitter on.
② "PAIR" (blinking sign) will be displayed on the LCD
screen and alarm sounds.
③ Blinking and alarm stops after approx. 5 seconds.
Then LCD screen displays PAIR .
Now the transmitter is ready.
④ Move receiver close to the transmitter (approx. within 1m)
⑤ Hold set button of the receiver then switch on.
⑥ Release set button. Receiver LED indicator turns on
after pairing is completed. Switch off both transmitter
and receiver.
Check movement
▶
① Switch on the transmitter first, then switch on the
receiver. Confirm that the receiver LED indicator lit up.
② Check movement of the servo and the amplifier.
▶Adjusting steering
Adjusting turning angle of the steering servo.
① Adjust MENU02: Steering trim to 0 (default setting)
② Adjust "MENU08: Steering sub-trim" so that the car run straight with the steering in neutral.
③ Operate steering wheel. Make sure that the setting does not lock the linkage. In this case,
reduce values in "MENU03: Steering travel".
If turning angle is not enough, adjust each left and right angle at the maximum in "MENU04:
Steering balance R" and "MENU05 steering balance L".
※If left and right turning radius are not same at low speed running, increase values of steering balance
of smaller radius to adjust. Adjust steering travel to reduce turning angle if car turns excessively while
high-speed running.
※Frequent setting or worn-out linkage will deteriorate balance of steering. Periodical adjustment is
recommended to keep performance of steering.
▶Adjusting throttle
Adjust the movement amount of speed controller (electric car) / throttle linkage (gas car)
When using with electric car: Refer to the instructions included with ESC.
▶
When using with gas R/C car: Adjust throttle linkage
▼
① Reduce values in MENU12: Throttle high point to avoid exerting excessive pressure on the
linkage when throttle is applied.
② Adjust in MENU13: Throttle brake to avoid exerting excessive pressure when brake is applied.
▶Adjusting anti-lock brake (ABS)
While in braking operation, pumping brake prevents wheel lock and being unstable
(Anti Lock Braking System). Braking power and pumping speed can be adjusted.
① Adjust ABS power in "MENU19: ABS power". Increase values to expand pumping width.
② Adjust ABS speed in "MENU20 ABS speed".
③ If servo moves more than brake pad stroke range or vibrates due to excessive speed,
it may shorten life span of the servo. In this case, re-adjust.
■ Pairing／Steering／Throttle／ABS
1. Forward key ＋ Back key
2. Power switch
2. Power
1. Set button
5
Advertisement
Table of Contents
