Instructions For Replacing The Lamps - ergoline SUNRISE 480 LED ADVANCED PERFORMANCE Operating Instructions Manual

Cleaning and maintenance
44/64
NOTICE:
Once the device has been in operation for longer than 10
years, it must be completely overhauled by a qualified
service technician.
4.8

Instructions for replacing the lamps

DANGER!
Danger of being burnt by an over-powered lamp!
If the old chip card is left in the device, the new lamp set will
be run at too high power and the user may suffer heavy
burns!
– The enclosed chip card must always be used when
changing the UV low pressure lamps!
The lamp's UV effect and therefore the tanning effect decrease over time. In
electronically controlled low pressure lamps, this loss of effect can be com-
pensated. The chip card is used to control the changing periods. You must
adhere to the replacement intervals specified in the maintenance plan.
NOTICE:
Small quantities of mercury can escape if the bulb/lamp
glass breaks!
Please comply with the following instructions:

Immediately disconnect the device from the mains pow-
er.

Children must leave the room immediately.

Ventilate the room for at least 15 minutes.

Put on disposable gloves.

With the window open: Collect the glass shards and
escaped mercury in a sealable container.

Bring the container to a collection site for waste lamps.