Operating Your Wine Cooler - Vinotemp Element EL-30SWCB2D Owner's Manual

OPERATING YOUR BEVERAGE COOLER
The appliance should be placed where the ambient temperature is between 32°F to 91°F. If the

ambient temperature is above or below this range, the performance of the unit may be affected.
For example, placing your unit in extreme cold or hot conditions may cause interior temperatures
to fluctuate.
Connect power cord to a properly grounded outlet.

This appliance is equipped with Memory IC – should there be a power interruption, unit will auto

recover at last setting.
Control Panel:
ON/OFF Power
To turn the appliance on or off, press and hold the ON/OFF button for 3 seconds.
Setting the temperature Control
 Adjustable temperature: 5℃ to 20℃
 Set the desired temperature by pressing the corresponding buttons,
decrease. Each press is in 1-degree increment. Once released, set temperature will flash for
approximately 5 seconds then revert back to display the internal temperature.
 To view your set temperature, press either the
set temperature for 5 seconds.
 The appliance has the capability to display temperature in either Celsius or Fahrenheit. To change
the temperature scale, press and hold both
seconds.
Note: The temperature of cans inside may vary slightly depending on whether or not the interior bulb is
ON or OFF and where the bottles are located (upper/middle or lower section).
RUN
When unit's compressor is running, this indicator light will illuminate to signify that cooling mode is
currently in operation.
1 7 6 2 1 S o u t h S u s a n a R o a d , R a n c h o D o m i n g u e z , C a l i f o r n i a 9 0 2 2 1
or
buttons simultaneously for approximately 3
i n f o @ v i n o t e m p . c o m
to increase or
button once and LED display will flash
to
11