JVC CA-MXS6MDR Service Manual page 28

CA-MXS6MDR
SP-MXS6MD
Removing the
assembly (See Fig.21)
Prior to performing the following procedure, remove
the servo control board and the clamper base unit.
1. Remove the three screws K attaching the traverse
mechanism assembly.
2. Detach the rear part of the traverse mechanism
assembly upward to release the joint o with the sub
chassis unit. Then remove the assembly from the
body.
Removing the feed motor (See Fig.22)
Prior to performing the following procedure, remove
the traverse mechanism assembly.
1. Remove the screw L attaching the feed motor.
Removing the tray select switch board
1. Remove the four screws B attaching the top cover
on the top of the body.
2. Remove the top cover with the two rods attached to
the top cover and the clamper base unit.
3. Remove the screw M on the right side of the body.
Top cover
1-28
traverse mechanism
(See Fig.5,6 and 23)
Clamper base unit
Fig.6
Traverse mechanism
assembly
Traverse mechanism assembly
B
Rod
Rod
K
Joint o
K
Fig.21
Feed motor
L
Fig.22
Top cover
Clamper base unit
Fig.5
Tray select switch board
M
CN620
Fig.23
K
B