JVC CA-MXS6MDR Service Manual page 19

<Reattaching the loading assembly>
1. Reattach the eject bar to the UD base.
2. Reattach the slide bar to the loading mechanism
chassis while fitting the boss marked k to the eject
bar slot. (Fig.20)
3. Slide the slide bar and the eject bar in the direction
of the arrow in Fig.20 and reattach the cartridge
holder assembly using the two screws I.
ATTENTION: Make sure the pin of the eject lever
marked l is fitted to the slot of the eject
bar marked m at the bottom of the
loading mechanism chassis after
moving the eject lever and the loading
slider of the cartridge holder assembly
in the direction of the arrow.
Ditch m
(Fig.15 and 20)
(Fig.20 and 21)
(Refer to Fig.21)
Slide bar
I
I
UD base (Bottom)
Cam switch board
Ditch
Eject bar
Fig.21
CA-MXS6MDR
SP-MXS6MD
H
Point marked
H
Cam switch boss
UD base
Fig.20
Cartridge holder assembly
Loading slider
Eject lever
l
1-19