JVC CA-MXS6MDR Service Manual page 15

<Loading assembly>
Removing the slide base (L) / (R)
1. Remove the two screws E on the upper side of the
loading assembly.
2. Remove the slide base (L) outward. (Release it from
the joint bosses E.)
3. Remove the slide base (R) outward.
Removing the
assembly (See Fig.11)
1. Detach the loading mechanism assembly upward to
release the four pins on both sides from the loading
motor, paying attention to the part e of the loading
mechanism base.
Loading mechanism assembly
Removing the loading motor
1. Disconnect the harnesses from the wire holder and
from connector CN612 on the cam switch board.
2. Remove the screw F attaching the loading motor
and release the joint f.
3. Remove the belt from the loading motor assembly.
4. Remove the two screws G
motor.
Removing the cam gear and the cam
switch board (See Fig.12)
1. Remove the slit washer attaching the cam gear and
pull out the cam gear.
2. Disconnect the harness from the wire holder and
from connector CN612 on the cam switch board.
3. Remove the two screws H and the clamp. Remove
the cam switch board.
(See Fig.10)
loading mechanism
(See Fig.12 and 13)
attaching the loading
Slide base (R)
Fig.10
Part e
Loading mechanism base
Loading mechanism
assembly
Fig.11
Loading motor assembly
Joint f CN612
F
Fig.12
Loading motor
Fig.13
CA-MXS6MDR
SP-MXS6MD
E'
E
Slide base (L)
E
E'
Wire holder
H
Cam switch board
Slit washer
H
Cam gear
G
Belt
1-15