JVC CA-MXS6MDR Service Manual page 27

Removing the pickup (See Fig.16 to 20)
1. From the top of the body, remove the three screws H
attaching the clamper base unit.
2. Remove the clamper base unit with the two rods
attached to the clamper base unit and the top cover.
3. Turn the screw shaft gear marked k in the direction
of the arrow to move the pickup unit.
4. Remove the screw I attaching the shaft holder.
5. Move the screw shaft in the direction of the arrow
and release it from the joint l. Then release it from
the joint m with the pickup holder. Detach the pickup
with the screw shaft.
6. Solder the part n of the flexible board on the
underside of the pickup. After soldering, disconnect
the flexible wire connected to the pickup (In case of
disconnecting the flexible wire without soldering, it
may cause damage to the CD pickup).
7. Remove the two screws J attaching the rack arm to
the pickup unit.
8. Pull out the screw shaft from the pickup.
Rack arm
Screw shaft
Flexible board
Part n (soldering)
Fig.19
J
Pickup
Fig.20
Top cover
H
Fig.16
Clamper base
Fig.17
Shaft holder
I
Fig.18
CA-MXS6MDR
SP-MXS6MD
Rod
H
Clamper base unit
Rods
Top cover
Joint m
k
Joint l
1-27