JVC CA-MXS6MDR Service Manual page 25

Removing the sub chassis unit
Prior to performing the following procedures, remove
the servo control board, the top cover, the tray unit,
the side unit (L) and the side unit (R).
1. Turn the hook gear counterclockwise to move the
slide hook and the slider (R) backward until they
stop.
2. Slide the slide cam (L) and the slide cam (R) in the
direction of the arrow until they stop.
(The notches of each slide cam are fitted to the pins
on both sides of the sub chassis unit.)
3. Detach the sub chassis unit upward.
ATTENTION: When reassembling, turn the hook gear
of the chassis unit counterclockwise until
it stops and slide the slide hook and the
slider (R) of the sub chassis unit
backward until they stop.
(See Fig.10 to 12)
slide hook
Slide cam (R)
Sub chassis unit
Pin
Notch
Slider (R)
Hook gear
CA-MXS6MDR
SP-MXS6MD
Slide cam (L)
Sub chassis unit
Fig.10
Pin
Slide cam (L)
Fig.11
Fig.12
1-25