(4)
Close the guide, and then take off the guide
by sliding its rear hinge to the right side.
(5)
Remove 1 spring and take off the guide while
the guide is being slid to the rear side.
(6)
Remove the Mylar.
(7)
Disconnect 1 connector, release 2 latches,
and then take off the exit sensor.
e-STUDIO163/203
FUSER / EXIT UNIT
Spring
Exit sensor
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
13 - 14
07/02
1
Fig. 13-15
Guide
Fig. 13-16
Connector
Mylar
Fig. 13-17
2