Disassembly And Replacement - Toshiba e-STUDIO163 Service Manual

8.5

Disassembly and Replacement

[A] Laser optical unit
(1) Take off the rear cover.
P.2-22 "[J] Rear cover"
(2) Disconnect 3 connectors from the MAIN
board.
Note:
Connect the flat harness to the MAIN board
with its erectrode side down. An error "CA2"
will be displayed if the connection is incor-
rect.
(3) Take off the switching regulator unit.
P.2-25 "[D] Switching regulator unit (PS)"
(4) Remove 1 screw.
(5) Pull out the laser optical unit while lifting it up
and take it off.
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Connector
Fig. 8-10
Laser optical unit
Fig. 8-11
8 - 7
Connector
e-STUDIO163/203
LASER OPTICAL UNIT
8