i3 International S81 User Manual page 11

Classification
Rate Limiting
Management
DHCP Server
Zero Touch Upgrade
Remote Monitoring (RMON)
Port Mirroring
UPnP
s-Flow
IEEE 802.1ab (LLDP)
Web GUI Interface
CLI
Dual Image
SNMP
Other Management
Power over Ethernet (PoE)
Port Configuration
PoE Scheduling
Auto-checking
Power Delay

Port based
 802.1p VLAN priority based
 IPv4/IPv6 precedence / DSCP based
 Differentiated Services (DiffServ)
 Classification and re-marking ACLs
 Ingress policer
 Egress shaping and rate control
 Per port
Support DHCP server to assign IP to DHCP clients
Upgrade single switch automatically when you get notification
Traffic on a port can be mirrored to another port for analysis with a network
analyzer or RMON probe. Up to N-1 (N is Switch's Ports) ports can be
mirrored to single destination port. A single session is supported.
Traffic on a port can be mirrored to another port for analysis with a network
analyzer or RMON probe. Up to N-1 (N is Switch's Ports) ports can be
mirrored to single destination port. A single session is supported.
The Universal Plug and Play Forum, an industry group of companies
working to enable device-to-device interoperability by promoting Universal
Plug and Play
The industry standard for monitoring high speed switched networks. It gives
complete visibility into the use of networks enabling performance
optimization, accounting/billing for usage, and defense against security
threats
 Used by network devices for advertising their identities, capabilities,
and neighbors on an IEEE 802ab local area network
 Support LLDP-MED extensions
Built-in switch configuration utility for browser-based device configuration
For users to configure/manage switches in command line modes
Independent primary and secondary images for backup while upgrading
SNMP version1, 2c and 3 with support for traps, and SNMP version 3 user-
based security model (USM)

HTTP/HTTPs; SSH
 DHCP Client/ DHCPv6 Client
 Cable Diagnostics
 Ping
 Syslog

Telnet Client
 IPv6 Management
Supports per port PoE configuration function
Supports per port PoE scheduling to turn on/off the PoE devices (PDs).
Check the link status of PDs. Reboot PDs if there is no responses.
The switch provides power to the PDs based on delay time when PoE
switch boots up, in order to protect switch from misuse of the PDs
10