i3 International S81 User Manual page 100

Form will return to the previously saved settings.
Static MAC Table
• Click Configuration / Add new Static Entry
• Select the VLAN IP and MAC Address Port Members
• Click Apply and click the Save icon in the upper right corner to save the settings or click Reset to cancel. The
Form will return to the previously saved settings.
MAC Address Table Configuration Parameters:
Items
Aging Configuration
MAC Table Learning
Static MAC Table
Configuration
Delete
VLAN ID
MAC Address
Port Memebers
Description
By default, dynamic entries are removed from the MAC table after 3000 seconds. This removal
is also called aging. Configure aging time by entering a value here in seconds. The allowed
range is 10 to 1000000 seconds. Disable automatic aging of dynamic entries by checking the
Disable automatic aging check box.
If the learning mode for a given port is greyed out, another module is in control of the mode,
so that it cannot be changed. An example of such a module is the MAC-Based Authentication
under 802.1X. Each port can do learning based on the following settings.
Auto: Learning is done automatically as soon as a frame with unknown SMAC is received.
Disable: No learning is done.
Secure: Only static MAC entries are learned, all other frames are dropped.
Note: Make sure that the link used for managing the switch is added ot the Static Mac Table
before changing to secure learning mode, otherwise the management link is lost and can only
be restored by using another non-secure port or by connecting to the switch via the serial
interface.
The static entries in the MAC table are shown in this table. The static MAC table can contain
64 entries. The maximum of 64 entries is for the whole stack, and not per switch. The MAC
table is sorted first by VLAN ID and then by MAC address.
Check to delete the entry. It will be deleted during the next save.
The VLAN ID of the entry.
The MAC Address of the entry.
Checkmarks indicate which ports are members of the entry. Check or uncheck as needed to
99