Remote Control; Battery Installation - Kenwood DDX9017DABS Instruction Manual

Ñ
Front Focus fine adjustment
1
Touch [Adjust].
2
Touch [Delay].
3
Set each item as follows.
Sound Image LR (Front)
■
Adjust the sound image to focus on in front
of front seats.
Sound Image LR (Rear)
■
Adjust the sound image to focus on in front
of rear seats.
Size of the Virtual Sound Field
■
Adjust the size of sound image to meet your
taste. If the sound image is shifted from the
front, adjust it by [Sound Image LR (Front)]
or [Sound Image LR (Rear)].
Subwoofer Delay
■
Adjust the delay time of subwoofer.
4
Touch [Level].
5
Touch [T] or [U] to adjust the sound level
of the selected speaker.
NOTE
• To return to the initial setting of Delay and Level,
touch [Initialize] and [YES] in the confirmation
screen.

Remote control

This unit can be operated using the remote
control.
# CAUTION
• Put the remote control in a place where it will
not move during braking or other operations.
A dangerous situation could result, if the
remote control falls down and gets wedged
under the pedals while driving.
• Do not leave the battery near fire or under
direct sunlight. A fire, explosion or excessive
heat generation may result.
• Do not recharge, short, break up or heat the
battery or place it in an open fire. Such actions
may cause the battery to leak fluid. If spilled
fluid comes in contact with your eyes or on
clothing, immediately rinse with water and
consult a physician.
• Place the battery out of reach of children. In
the unlikely event that a child swallows the
battery, immediately consult a physician.

Battery Installation

If the remote control operates only over
shorter distances or does not operate at all, it
is possible that the batteries are depleted.
In such instances, replace the both batteries
with new ones.
1
Insert two "AAA"/"R03"-size batteries
with the and poles aligned properly,
following the illustration inside the case.
Remote control
71
English