Table of Contents
Advertisement
7
Control panel settings B-Control
7.1
List of parameters
Tab.5
Information list
Information
°C
°C
°C
7.2
Setting the parameters
Fig.33
Fig.34
7642056 - v05 - 30012017
Description
Heating water temperature (°C)
Domestic hot water temperature (°C)
Outside temperature (°C)
Burner status
Energy meter on the heating water circuit
Energy meter on the domestic hot water circuit
Information on the boiler not available
MW-3000243-3
MW-3000244-3
7.1.1
Information menu
Display
The symbol
The symbol
For more information, see
Browsing in the menus, page 17
7.2.1
Setting the heating water temperature
No temperature sensor connected
Set the heating water temperature
setpoint
1. Set the temperature setpoint or room temperature depending on the
configuration described above by turning the setting button
Note
If the heating water temperature setpoint is lower than 16°C and if
no outside temperature sensor is connected, the heating cuts out
automatically.
Note
This setting is possible regardless of the display.
2. Go back to the main display by pressing the
Note
After five seconds without pressing any keys on the control panel,
the display goes back to the main display.
7 Control panel settings B-Control
flashes
The symbol
flashes
If no domestic hot water sensor connected: dis
play — — —
flashes.
The symbol
flashes.
The displayed value flashes.
The symbol
flashes.
The displayed value flashes.
Outside temperature sensor con
nected
Set the required room temperature
.
key for two seconds.
EFU C
23
Advertisement
Table of Contents
