Selecting A Pcb; Shutdown; Switching Off The Heating - NeOvo Condens EFU C 40 User Manual

6 Utilisation with the control panel IniControl 2
Fig.25
MW-2000369-1
Fig.26
6.3

Shutdown

Fig.27
MW-5000027-4
20 EFU C
3. Open the oil inlet valve.
4. Switch on the boiler.
A venting cycle is run automatically.
The display shows the operating status of the boiler, the heating flow tem­
perature and any error codes.
6.2.1

Selecting a PCB

1. Access the menus by pressing the two keys on the right simultane­
ously.
2. Access the PCB selection menu (only when several PCBs are
present).
Important
The PCB selection menu is available only when the
es.
3. Scroll through the names of the connected additional PCBs by
pressing the or
The names of the installed PCBs will be displayed in sequence.
4. Confirm the required PCB by pressing the
Note
The flow temperature for the selected PCB is displayed by default,
as well as the status of the pump(s) and the status of the valve
connected to the selected PCB.
5. Go back to the main display by pressing the
For more information, see
User menu, page 25
COUNTERS/TIME PROG/CLOCK menus, page 28
Modifying the User parameters, page 29
6.3.1

Switching off the heating

Note
Heating mode can be managed via the TIME PROG sub-menu
dedicated to timer programming.
1. Go to stop mode by pressing the
keys.
key.
key.
7642056 - v05 - 30012017
icon flash­
key.