Page 2
+44 (0) 1626 323100 Email sales@westomatic.com Westomatic Vending Services Ltd. reserves the right to change the product specifications at any time. While every effort has been made to ensure that the information in this publication is accurate, Westomatic Vending Services Ltd disclaims any liability for any direct or indirect losses howsoever caused arising out of use or reliance on this information.
Page 3
There are no user serviceable parts inside this vending machine. • The Sigma Light machine must be cleaned on a regular basis (refer to the section within this • document on how to clean your machine). A water jet must not be used.
Page 5
All details and indications for the installation and cleaning of this vending machine have been made under consideration of our knowledge and experiences collected up to now. Westomatic Vending Services Ltd. reserves the right to make technical changes to this machine type without notice as a result of continuous product development.
Note the extent of any damage on the transport documents/delivery note of the forwarding agent. If required, please contact the Westomatic helpline as soon as possible to register any product damage as a customer complaint can only be asserted within the currently valid time limits.
Page 13
ALWAYS SWITCH OFF AND DISCONNECT THE MACHINE FROM THE MAINS ELECTRICITY SUPPLY BEFORE CLEANING OR THE REMOVAL OF PARTS. The quality of drinks produced by the Sigma Light can only be maintained if the machine is cleaned regularly following the required cleaning schedule.
Reference should be made to the model water bylaws 1986 statutory instrument (SI) No.1147 Noise levels The Sigma Light has been designed to work within a user-friendly environment and will therefore not exceed a noise level of 70dB. Operating conditions The Sigma Light machine is suitable for indoor use between +10°C and +30°C.
The Sigma Light has been designed to be able to be quickly and easily installed and provide good quality, well presented drinks from power up. Access to the maintenance area of the machine is via the Light screen technology provided.
Turn screw the 15mm fitting of the mains water supply hose (supplied with the machine) to the rising water main via a stopcock. (Fig1). Now connect the ¾ inch connector to the Sigma Light and turn the stopcock on and check for leaks). For water pressure guidelines see page 25.
Page 33
Bean to cup – Run a dry throw Very important Upon receipt of your Sigma Light you will need to calibrate the machine to suit your coffee beans. If you cannot carry out this procedure yourself, your machine is going to fail very quickly! This is a two part process and must be done in the following order.
Page 36
Small flat headed screw driver – watch type Please note that your Sigma Light hot beverage machine has been through a full test procedure at Westomatic Vending Services Ltd. However the cup which we used to test the cup sensor on your machine may differ to the cup which you are about to load into the cup turret tubes.
Page 37
Enter PRICE SETTINGS Adjust the price of the drink/s If your Sigma light has been ordered as a payment set up, the programming will already enabled for you i.e the machine will be programmed to payvend. If however you need to change the settings at a later date this can be carried out in:...
Need help?
Do you have a question about the Sigma Light and is the answer not in the manual?
Questions and answers