Power Trim And Tilt Switch On Remote Control; Power Trim And Tilt Switch On Bottom Cowling - Yamaha FL150A Owner's Manual

With the main switch in the "
sition, the starter motor turns to start the en-
gine. When the key is released, it returns
automatically to the "
ON
OFF START
EMU32053
Power trim and tilt switch on remote
control
The power trim and tilt system adjusts the out-
board motor angle in relation to the transom.
Pushing the switch "
board motor up, and then tilts it up. Pushing
the switch " " (down) tilts the outboard motor
down and trims it down. When the switch is re-
leased, the outboard motor will stop in its cur-
rent position. For instructions on using the
power trim and tilt switch, see pages 51 and
53.
" (start) po-
" (on) position.
ON
OFF START
ZMU04566
" (up) trims the out-
EMU26154
Power trim and tilt switch on bottom
cowling
The power trim and tilt switch is located on the
side of the bottom cowling. Pushing the switch
" " (up) trims the outboard motor up, and
then tilts it up. Pushing the switch "
tilts the outboard motor down and trims it
down. When the switch is released, the out-
board motor will stop in its current position.
For instructions on using the power trim and
tilt switch, see page 53.
EWM01031
WARNING
Use the power trim and tilt switch located
on the bottom cowling only when the boat
is at a complete stop with the engine off.
Attempting to use this switch while the
boat is moving could increase the risk of
falling overboard and could distract the
operator, increasing the risk of collision
with another boat or an obstacle.
Components
" (down)
21