Maintenance; Transporting And Storing Outboard Motor; Storing Outboard Motor - Yamaha FL150A Owner's Manual

Maintenance

EMU31844
Transporting and storing out-
board motor
EWM02640
WARNING
USE CARE when transporting fuel tank,
G
whether in a boat or car.
DO NOT fill fuel container to maximum
G
capacity. Gasoline will expand consider-
ably as it warms up and can build up
pressure in the fuel container. This can
cause fuel leakage and a potential fire
hazard.
Leaking fuel is a fire hazard. Tighten se-
G
curely the fuel valve when transporting
and storing the outboard motor.
Never get under the outboard motor
G
while it is tilted. Severe injury could oc-
cur if the outboard motor accidentally
falls.
Do not use the tilt support lever or knob
G
when trailering the boat. The outboard
motor could shake loose from the tilt
support and fall. If the outboard motor
cannot be trailered in the normal run-
ning position, use an additional support
device to secure it in the tilt position.
ECM02440
NOTICE
When storing the outboard motor for pro-
longed time, fuel must be drained from the
fuel tank. The deteriorated fuel could clog
the fuel line causing engine start difficulty
or malfunction.
Leaking fuel is a fire hazard. When trailering
the boat, close the fuel valve to prevent fuel
from leaking.
The outboard motor should be transported
and stored in the normal running position. If
there is insufficient road clearance in this po-
58
sition, then trailer the outboard motor in the tilt
position using a motor support device such as
a transom saver bar. Consult your Yamaha
dealer for further details.
When the outboard motor is tilted prolonged
time for mooring or trailering the boat, close
the fuel valve.
EMU30041

Storing outboard motor

When storing your Yamaha outboard motor
for prolonged periods of time (2 months or
longer), several important procedures must
be performed to prevent excessive damage. It
is advisable to have your outboard motor ser-
viced by an authorized Yamaha dealer prior to
storage. However, you, the owner, with a min-
imum of tools, can perform the following pro-
cedures.
ECM01350
NOTICE
To prevent problems which can be
G
caused by oil entering the cylinder from
the sump, keep the outboard motor in
the attitude shown when transporting
and storing it. Do not store or transport
the outboard motor on its side (not up-
right).
Do not place the outboard motor on its
G
side before the cooling water has
drained from it completely, otherwise
water may enter the cylinder through the
exhaust port and cause engine trouble.
Store the outboard motor in a dry, well-
G
ventilated place, not in direct sunlight.
Drain the remaining gasoline from the
G
vapor separator. Gasoline left in the va-
por separator for a prolonged period of
time will break down and could cause
damage to the fuel line.