Fisher & Paykel CG363MLNGB1 User Manual page 18

Care and cleaning
16
US
CA
Cleaning the pan supports (the pan support pins and burner head)
Important!
Do not wash pan supports in a dishwasher or use dishwashing machine detergent to clean these
parts as this may damage the easy-clean coating.
After reassembling any burner, always lower the burner before using the CookSurface to check it
has been reassembled correctly.
If food spills have burnt onto the pan supports, the supports may not lower when the control
dial is pressed and held for two seconds. This is not a fault. You need to remove and clean them.
To clean the pan support pins
Press the on/off power button to turn the CookSurface on.
1
Press the control dial to raise the pan supports.
2
Press the on/off power button to turn the CookSurface off.
3
Gently pull the pan support pins up and out. If food has become burnt onto the pins and the
4
surrounding ceramic glass, it may be necessary to gently twist the pin to remove it.
Soak the pins in warm water with a little hand dishwashing (or other mild) detergent. The pins
5
have an easy-clean coating. Harsh or abrasive cleaners should not be necessary and may damage
the coating.
Wipe with a soft cloth and dry thoroughly.
6
Carefully replace all the pan support pins correctly.
7
Press gently to clip into position.
8
Burner head
Pan support pin
Fig.4 Removing the pan supports