Mercury Jet 40 Manual page 37

3. Connect the fuel line to the outboard.
4. Squeeze the fuel line primer bulb several times until it feels firm.
NOTE: The engine will not start unless the lanyard is set to the "RUN" position.
5. Set the lanyard stop switch to the "RUN" position. Refer to General Information - Lanyard Stop Switch.
6. Shift outboard to neutral (N) position.
7. Models without power trim - Position tilt lock lever to the lock position.
OPERATION
ob00350
N
ob00351
33
ob00348
ob01445
ob00349
N
ob01446