The Vehicle Seat Belt; Placing The Carrier In The Base - Evenflo Embrace 35/PRO Owner's Manual

2
F
IMPORTANT: Some ELR vehicle belts can be switched so
that they lock when tightened. It may not be necessary
to use a locking clip in these situations.
To install a locking clip, refer to p. 41.
Refer to the vehicle owner's manual to determine which
type of belt retractor is in the vehicle.
LAP BELT
3
H
G
Secure the base to your
vehicle seat by routing

the vehicle seat belt

through the openings
on the sides of the base.
LAP AND
SHOULDER BELT
Pull the shoulder
belt tightly to remove
G
all slack from the lap
portion of the belt ,
H
at the same time push
down on the base using
your full weight. Check
to be sure the base is
secured in the vehicle
seat.
24
4
F
Make sure the vehicle belt is tight. Grab the base at the
areas , as shown. If you can move the base more than
I
25 mm (1 inch) side-to-side or front to back the vehicle
belt is not tight enough. You will need to try again, or
find another location for your convenience base.
IMPORTANT: Route any excess vehicle belt through
the openings
not interfere with the metal carrier retainers
when attaching the carrier.

Placing the Carrier in the Base

1
F
J
I
WARNING
, on the sides of the base, so it does
F
Secure the carrier to the
base by placing it into
the base and pressing
down on the front and
back.
The carrier
locked firmly into the
base. Check by lifting
up on the carrier handle
or the front of the
carrier to make sure it's
locked in place.
25
J
MUST be