Options And Settings - Lincoln Electric POWER MIG 210 MP Operator's Manual

PRODUCT MODEL

OPTIONS AND SETTINGS

MIG OPTIONS
The inductance option permits adjusting the arc performance,
this option can be used to help with starting and the weld bead
profile. A higher inductance setting provides a softer arc and a
lower inductance setting provides a crisper arc.
The spot time option permits adjusting the duration of the
welding arc. This is used for tack welds or spot welds. The
spot-time option is available in GMAW and FCAW modes.
The run-in option permits adjusting the wire feed speed prior to
the arc being established. A lower run-in speed permits smooth
arc starts. After the arc is established the run-in value is
inactive and the set wire feed speed is present. The run-in
option is available in GMAW and FCAW modes.
SMAW OPTIONS
The arc force option permits the user to control the penetration
profile. A high arc force value creates a crisp arc while a low
arc force value creates a soft arc. The arc force option is
available in SMAW mode.
The hot start option permits adjusting the amperage during arc
initialization. After the arc is established the welding current will
decrease to the output current set by the user. The hot start
option is available in SMAW mode.
SETTINGS
The brightness of the display can be adjusted within the
settings option.
The user interface software settings can be reset to the original
factory settings.
Information regarding the software revision of the user interface
and the software revision of the inverter board is present in the
information section.
The language of the text present in the user interface software
can be modified. The available language options are English,
French and Spanish. The default language is English.
The units of measure can be chosen by the user. The units can
be selected as metric or English. The default units are English.
AVAILABLE EQUIPMENT OPTIONS
The Power MIG 210MP is Magnum PRO 100SG spool gun ready.
To permit welding with a spool gun, the user must configure the
switch located above the wire drive to the spool gun position.
The spool gun is recommended for aluminum welding.
Reference the options page present within the manual for more
information regarding the available TIG torches and adapters.
To permit adjusting welding current with a foot pedal during TIG
welding, the K4104-1 foot pedal adapter must be installed into the
machine. The adapter is to be secured to the center panel beneath
the wire drive. After the adapter is installed, the TIG foot pedal
icon must be selected within the user interface. The output of the
machine can be activated and deactivated with the foot pedal.
22
OPERATION