Front Brake - Eton beamer R2-50 Service Manual

FRONT WHEEL AXLE BEARING INSPECTION
Spin the wheel. Replace with a new bearing if needed.
INSPECT THE FRONT RIM
Check the rim swing limit.
Limit: Replace if the swing is over 2.0mm

8.6 FRONT BRAKE

REPLACING THE FRONT DISK BRAKE
CALIPER
ASSEMBLY
Unscrew the two front disk brake caliper fixing bolts.
Take off the front disk brake caliper.
Torque value when replacing: M8 nut: 14 - 22 lbf-ft
REMOVING THE AIR FROM THE FRONT DISK
BRAKE CALIPER
Fill the brake reservoir with the recommended DOT3
brake fluid in the brake master cylinder at the right
handlebar (see picture).
Be careful not to spill any brake fluid when refilling.
Release and lock the bleeder valve at the disk brake
caliper.
Beamer R2 Rev 1.0 Page 38 of 56 6/13/2007