Front Wheel - Eton beamer R2-50 Service Manual

Remove the fixing nut and handlebar bolt on the front
fork. Remove the handlebar.
Torque when installing a handlebar:
M6 nut: 7 - 9 lbf-ft
M10 nut: 22 - 29 lbf-ft

8.5 FRONT WHEEL

Remove the locking nut at the right side of the front
wheel.
Pull out the front wheel axle. Take off the collar.
Remove the speedometer gear unit.
Remove the front wheel assembly.
Torque when replacing the front wheel:
M10 nut: 22 - 29 lbf-ft
NOTE: Apply the grease on the speedometer gear unit
before assembly.
INSPECT THE FRONT WHEELAXLE
Check the wheel axle for bending.
Standard maximum: 0.2 mm
Beamer R2 Rev 1.0 Page 37 of 56 6/13/2007