Network Configuration; Connecting Your Radio To Your Computer Network - Sangean WFR-29D Manual

Configuration

Connecting your radio to your computer network

1. Place your radio on a flat surface and plug the mains lead into the mains socket located on the
left side of your radio ensuring that the plug is pushed fully into the socket.
2. Plug the other end of the mains lead into the wall socket and switch on the wall socket.
IMPORTANT: The mains plug is used as the means of connecting the radio to the mains supply.
The mains socket used for the radio must remain accessible during normal use.
In order to disconnect the radio from the mains completely, the mains plug should be removed
from the mains socket outlet completely.
3. When you apply power, the display on the radio will light up and say: 'SANGEAN' and 'STARTING'
with a progress indicator. The first time that you use your radio (or after Factory Reset) the
display will show "Setup wizard" and "YES" will be highlighted on the screen. Press the Tuning
Control Rotary to start the setup wizard. The screen will ask if you wish to run the setup wizard
again at the next start up. This will lead to the main menu.
. Rotate the Tuning Control Rotary on the right hand side of the unit to highlight the desired
clock format (either 12 or 24 hour) then press the Tuning Control Rotary to enter your selection.
A menu allowing you to specify the auto update option for the clock will appear on the display.
The default of 'Update from Network' will be the best option for most users.

SANGEAN
3,4