Snooze Timer; Disabling Alarms - Sangean WFR-29D Manual

When the alarm sounds
The buzzer or radio alarm will sound at the selected times for up to 60 minutes unless cancelled.
The volume used for the alarm will be as specified during the alarm setting procedure. If the radio
cannot connect to the specified radio station, the buzzer alarm will be used instead. To cancel
an alarm, press the Standby button to return to standby mode. The alarm icon will flash at the
bottom of the playing mode displays, and the radio will automatically switch back to standby
mode when the 60 minutes have elapsed.
Note: If you have your earphone insert while the alarm is sounding, the sound of the alarm will
come out from your earphone.

Disabling alarms

1. To disable a single alarm enter the alarm setup menu and rotate the Tuning Control Rotary until
the desired alarm is highlighted on the display. Press the Tuning Control Rotary to confirm.
. Rotate the Tuning Control Rotary until the 'Enable:' option is highlighted on the display. Press
the Tuning Control Rotary.
. Rotate the Tuning Control Rotary to highlight 'Off' and press the Tuning Control Rotary.
. Rotate the Tuning Control Rotary until the 'Save' option is highlighted on the display then
press the Tuning Control Rotary to save the new setting. The chosen alarm will now be disabled.

Snooze timer

1. The buzzer or radio alarm can be silenced for 5 minutes by pressing the Alarm button. Should
you wish for a longer snooze duration this can be extended. Pressing the Alarm button again
while the radio is snoozed will set the available snooze time to 5, 10, 15 or 30 minutes.
2. While the snooze timer is active the remaining snooze time is shown next to the flashing alarm
icon on the clock display.
3. In order to cancel the Snooze timer while the alarm is suspended, press the Standby button.
The display will briefly show an 'Alarm Off' message.
1
1-4
GB
66