Table of Contents
Advertisement
Brightness control
The brightness of the display can be adjusted for when the radio is in standby and for when it is
in use. If you use the unit in the bedroom, you may prefer a lower standby brightness level than
the standard setting. There are three brightness levels and an almost off 'night-time' setting.
. Press the Standby button to switch on your radio. Access the menu for the current mode by
pressing the Menu button.
. Rotate the Tuning Control Rotary until 'System settings' is highlighted on the display. Press
the Tuning Control Rotary to enter the system settings menu. Rotate the Tuning Control
Rotary until 'Brightness' is highlighted on the display. Press the Tuning Control Rotary to
confirm the setting.
3. To adjust the display brightness when the radio is switched on rotate the Tuning Control
Rotary until 'Normal' is highlighted on the display. To adjust the display brightness when the
radio is in standby rotate the Tuning Control until 'Standby' is highlighted. Press the Tuning
Control Rotary to enter the selected brightness adjustment mode.
4. To adjust the brightness level rotate the Tuning Control Rotary on the radio to increase the
brightness level and the Tuning Control Rotary to decrease it. The backlight level will change
so that you can see the effect of each setting. Note that the backlight is almost completely off
at the zero setting. Press the Tuning Control Rotary to set the level.
When the radio is in Standby mode, pressing a button will cause the radio to switch to the Normal
brightness level for a few seconds. This is so that even if the Standby brightness level is set to
zero (almost off), it is still possible to see the time by quickly pressing a button.
1
1
2-4
Advertisement
Table of Contents
