Sangean WFR-29D Manual page 66

Setting the alarm clock - cont.
0. Rotate the Tuning Control Rotary until the 'Volume:' option is highlighted on the display and
press the Tuning Control Rotary if you wish to change it. The radio uses the saved volume
setting for each alarm when it sounds. Set the required volume using the Tuning Control
Rotary to confirm the setting.
11. In order to store the alarm settings rotate the Tuning Control Rotary until 'Save' is highlighted.
Press the Tuning Control Rotary to store the alarm settings. Your radio will show 'Alarm
saved' and will then go back to the list of alarms with the new alarm setting shown in the display.
If you decide not to save the settings, press the Back button. The display will show 'Save
changes' with a 'YES' or 'NO' option. Rotate the Tuning Control Rotary to choose 'NO' and then
press the Tuning Control Rotary. 'Alarm not saved' will show on the display. Active alarms are
shown using small alarm indicators at the bottom of the playing displays and on the clock display
when in standby.
Note: If you make a mistake at any point while setting the alarms, use the Back button to go
back to the previous screen.
65
10,11
11