Fm Mode - Sangean WFR-29D Manual

FM Radio
Operating your radio in FM mode
1. Carefully extend the telescopic aerial and press the Standby button to switch on your radio.
. Press the Mode button as needed to select FM radio mode.
. Rotate the Tuning Control Rotary and then press the Tuning Control Rotary. The displayed
frequency will increase. Your radio will scan up the FM band from the currently displayed
frequency and will stop scanning when it finds a station of sufficient strength.
4. The display will show the frequency of the signal which has been found. If RDS information is
available, after a few seconds the display will show the radio station name. If you only hear hiss
or interference, simply press the Tuning Control Rotary to scan further. Your radio may have
found a spurious interference signal.
5. To find more FM stations press the Tuning Control Rotary to repeat the scan operation. To scan
down in frequency, rotate the Tuning Control Rotary and then press the Tuning Control Rotary.
Your radio will scan down the FM band from the currently displayed frequency and will stop
scanning when it finds a signal of sufficient strength.
6. When the end of the waveband is reached your radio will recommence tuning from the opposite
end of the waveband. Use the Volume control knob to adjust the sound level as needed.

1
2
3-5
6