Table of Contents
Advertisement
Quick Links
This .pdf document is bookmarked
Instructions and Parts Manual
PM1900TX Dust Collector
Now with
PM1900TX with Filter Bag Kit (1792071K)
PM1900TX with Canister Kit (1792072K)
Powermatic
427 New Sanford Road
LaVergne, TN 37086
Part No. M-1792071
Ph.: 800-274-6848
Revision B1 09/2018
www.powermatic.com
Copyright © 2014 Powermatic
Advertisement
Table of Contents
Related Manuals for Powermatic PM1900TX
Summary of Contents for Powermatic PM1900TX
- Page 1 This .pdf document is bookmarked Instructions and Parts Manual PM1900TX Dust Collector Now with PM1900TX with Filter Bag Kit (1792071K) PM1900TX with Canister Kit (1792072K) Powermatic 427 New Sanford Road LaVergne, TN 37086 Part No. M-1792071 Ph.: 800-274-6848 Revision B1 09/2018 www.powermatic.com...
-
Page 2: Important Safety Instructions
If used for other purposes, starter keys. Powermatic disclaims any real or implied warranty and holds itself harmless from any 20. Give your work undivided attention. Looking injury that may result from that use. - Page 3 28. Do not use without dust bag and/or filters in 36. Do not stand on the machine. Serious injury place. could occur if the machine tips over. 29. Do not handle plug or machine with wet WARNING: This product can expose you hands.
-
Page 4: Table Of Contents
Replacement Parts ............................13 Breakdown for PM1900TX Dust Collector (Base Machine) ..............13 Parts List for PM1900TX Dust Collector (Base Machine) ............... 14 Parts List and Breakdown for PM1900TX Filter Bag System..............16 Breakdown for PM1900TX Canister Filter System .................. 17 Parts List for PM1900TX Canister Filter System .................. -
Page 5: Introduction
Stock Numbers: ............................... PM1900TX (Base Machine A), includes 3HP, 1PH Motor, Remote Control and Mag. Starter ..1792071 PM1900TX (Base Machine B), includes 3HP, 3PH Motor, 230V/460V, (Pre-wired 230V) ... 1792073 PM1900TX (Base Machine A) with Filter Bag System ..............1792071K PM1900TX (Base Machine A) with Canister Filter System ............ -
Page 6: Unpacking
Unpacking Remove all contents from the shipping carton and check against the Contents of Shipping Carton below to verify that all items have been received. Report any damage to your distributor. Do not discard any shipping material until after the dust collector has been assembled and is running properly. -
Page 7: Base Machine Assembly
3. Insert an M8x20 hex cap screw (A), through the Base Machine Assembly M8 washer (D) and flanges of the connector tube (R) and impeller housing (N). The dust collector must not be connected to the power source 4. Place another washer (D) and a hex nut (F) on during assembly. -
Page 8: Handles
Note: Make sure the plate (Y) is oriented Filter System properly, as shown in the Detail in Figure 3: The If your PM1900TX Dust Collection system includes protrusions on the plate should face away from filter bags, proceed to Filter Bag System Assembly on the handle. -
Page 9: Filter Bag System Assembly
9. Thread the retainer strap (Figure 6) through Filter Bag System Assembly the loops on the filter bag, and fasten it to the collector housing, as shown in Figure 7. Note: If your dust collection system includes the canister kit, proceed Canister System... -
Page 10: Canister System Assembly
6. Insert and tighten the four knobs into the Figure 10 threaded holes on the canister (Figure 10). Note: The Powermatic® label on the front of the canister should have a negligible effect upon air flow. However, if zero effect is desired, the label... -
Page 11: Electrical Connections
Extension Cords injury. If an extension cord is needed, make sure the The PM1900TX is equipped with either a single cord rating is suitable for the amperage listed on phase, 230 volt only motor; or a three phase, the machine’s motor plate. An undersize cord 230/460V motor (pre-wired 230V). -
Page 12: Setting The Timer (1-Phase Models)
Properly Contact your nearest Powermatic distributor for discard the plastic bag. a full line of Dust Collector hoses and accessories. -
Page 13: Replacement Parts
Non-proprietary parts, such as fasteners, can be found at local hardware stores, or may be ordered from Powermatic. Some parts are shown for reference only, and may not be available individually. -
Page 14: Parts List For Pm1900Tx Dust Collector (Base Machine)
21 ..... PM1900-121 .... Right Housing................... 1 22 ..... PM1900-122 .... Support Bar ....................2 23 ..... PWBS14-254SN ..POWERMATIC Nameplate, Small ............1 24 ..... TS-2361061 ..... Lock Washer ............M6 ....... 2 25 ..... TS-1550041 ..... Flat Washer ............M6 ....... 2 26 ..... - Page 15 73 ..... TS-1482021 ..... Hex Head Bolt ............M6x12 ......8 74 ..... TS-2311061 ..... Hex Nut ..............M6 ....... 8 ....PM1300-162 .... Powermatic Turbocone Decal (not shown) ..2-3/4 x 8” ..... 1 ....PM1900-BMHP ..Base Machine Hardware Package (not shown)* ........1 ....
-
Page 16: Parts List And Breakdown For Pm1900Tx Filter Bag System
Parts List and Breakdown for PM1900TX Filter Bag System Index No. Part No. Description Size ....1791075B ....Collection and Filter Bag System (includes #1 thru 6) ......1 1 ....1791075F ....Filter Bag .............. 30 micron ....2 2 .... -
Page 17: Breakdown For Pm1900Tx Canister Filter System
Breakdown for PM1900TX Canister Filter System... -
Page 18: Parts List For Pm1900Tx Canister Filter System
23 ..... 331015 ..... Plate ......................2 24 ..... TS-1482021 ..... Hex Cap Screw ............ M6x12 ......4 ....PM1300-PLO ... Powermatic Label (not shown)......5-1/2x14 Oval ..... 1 ....PM1900-CHP ... Canister Hardware Package (not shown) * ..........1... -
Page 19: Electrical Connections
Electrical Connections Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction. POWER SUPPLY CORD BLACK WHITE 2 3 0 V 1 1 5 V MOTOR CORD M O T O R... -
Page 20: Warranty And Service
Powermatic sells through distributors only. The specifications listed in Powermatic printed materials and on the official Powermatic website are given as general information and are not binding. Powermatic reserves the right to effect at any time, without prior notice, those alterations to parts, fittings, and accessory equipment which they may deem necessary for any reason whatsoever.
Need help?
Do you have a question about the PM1900TX and is the answer not in the manual?
Questions and answers